added information about flash diagnosis via power consumption of the VTX

[hugepanic]

No description provided.

[BlackFox-org]

A lot of errors(grammar and software).

This info was gathered from the RunCam Support in on 06/2025:

To asses determine if Uboot is still accessible, the current of the Wifilink2 can be should be measured and compared to give given values.
This can be achieved by a regulated power supply and/or a multimeter.
Power will be should be applied via the 6pin FC connector

Case	Voltage	Amps	Power	Status
1	13.5 V	0.182 A	2.5 W	Uboot still accessible This suggests the firmware flash failed, but U-Boot is still present. (device is not fully bricked) Firmware flash error, can be fixed with UART flashing.
2	13.5 V	<=0.144 A	<= 1.9 W	Uboot missing/unavailable. propably Bricked Need full reflash using chip programmer

[BlackFox-org]

Thanks for your commitment!