I can't figure out how to set this up

[ncp1113]

I feel like I am missing something obvious. I added Tesla-local-control through the add-on store. HA 2025.6.1. I set up a raspberrypi zero w and I paired the bluetooth to the Tesla (2016 Model S). The add on documentation says
Fill in the required settings:

vin_list: single VIN or list of VINs separated by either of | , or space; Required
mqtt_server: Hostname or IP of your MQTT server; Default 127.0.0.1
mqtt_port: MQTT service port; Default 1883
mqtt_useranme: MQTT Username; Default anonymous
mqtt_password: MQTT Password
debug: Activate if you are having issues, you will most likely not need it; Default off

But there are no configuration settings to fill in. I can't figure out where I am supposed to enter that info.
Help would be appreciated.

[lukej0]

Hi, it should look like this in HA, when you open the Addon

[ncp1113]

Thank you very much. When I opened it after installing, that was blank. Now it is there. However, since then I installed mosquitto on the raspberryPi. Maybe that made a difference?

[vanhoofseppe]

I think I'm missing a step:

2 -> Where can I find the button in HA to generate the public and private keys?

`Pair key with your car (if not already done)
If this is the first time you run the addon, you will need to pair with your car. For this:

1. Ensure your car is not too far from your HA system (within BLE reach)
2. Press the 'Generate Keys' button in HA. This will generate the public and private keys
3. Go inside your car and authenticate by placing your key card on the center console
4. In HA press the button 'Deploy Key' (you can use the companion app). This will deploy the public key to the car. If the command succeeds, the following will show in the add-on logs: KEY DELIVERED; IN YOUR CAR, CHECK THE CAR's CENTRAL SCREEN AND ACCEPT THE KEY USING YOUR NFC CARD
5. You will then see a message on screen to accept the new key. Press accept. If the command succeeds, the following will show in the add-on logs: acceptKeyConfirmationLoop; congratulation, the public key has been accepted vin:$vin`